1. Measure total width of base of garage door to be sealed.

2. Cut Gapstop to required length.

3. Check the following sketches and decide which one best suits your needs.

4. Using the tesa surface cleaning wipe provided, clean surface of Gap Stop where double sided tape is applied.
(Put wipe back into packet to use later).

5. Take double sided tape, peel off to approx. 15cm at a time from the roll and apply to Gap Stop in the position required.

6.Now take Gap Stop with the tape attached, carefully peel off approx. 15cm of the red backing film at a time and position it onto garage door, press down firmly until completely fixed.